How to Flash a 35T DMA Card

All of this will be done on the Second-PC unless specifically instructed otherwise.

or Squirrel 35T / Captain 35T DMA

1. Make sure the DMA is properly inserted in a PCIe slot on the Gaming-PC.

2. Make sure that the Gaming-PC is powered on.

3. Plug the DMA USB-Cable into the "Update" port or "JTAG" on the DMA Card and the other end into the 2nd-PC.

Download DMA Flash Files: DMA-Flash-Files

4. Go into the Flash Tools folder and open "zadig-2.8.exe". 5. In Zadig open "Options" - Tick "List All Devices" and select "Quad RS232-HS (Interface 0)"

-> It is important that you select "Interface 0"!

-> If you do not see the "Quad RS232-HS" options and instead see a "FTDI SuperSpeed-FIFO Bridge" it most likely means that you are plugged in the Data port and not the Update Port.

・Make sure the driver where the arrow is pointing at says WinUSB ("Version number") and press Replace Driver.

-> Make sure that it says that the installation was successful and it looks like the after picture.

1. Go into the OCD folder.

Copy your firmware file into Flash Tools folder and change the Flash_screamer config to that name. as shown in the image below.

Double click flash.bat file →Might take up to 5 minutes.

Make sure it looks like in the picture below!

7. After Shows Shutdown Command invoked in the last line, Change to the Data USB-Port on the DMA.

8. Fully shutdown Main PC and wait 3-5 Minutes

9. Run DMA Speed Test File as Admin. If, DMA test shows reading means DMA Working.

You are done with the flashing guide.